Hardware User Manuals

Watch out that pin 1 position and alignment of all pins match when connecting two parts together.

1. Mount the Solder part on the embedded target PCB.

2. If an optional Extender is used, connect it to the Solder part. The Extender can also provide a protection from damaging the Solder part if the Emulation Adapter setup is supposed to be assembled and disassembled during the usage. In such case, it is recommended that the Emulation Adapter is disconnected from the Extender and not from the Solder part. If the Emulation Adapter setup needs to be disassembled, be cautious and gentle during this procedure since all parts of the assembly are very sensitive and pins can easily bent or even break in worst case.

More Extenders can be stacked to gain height between the Emulation Adapter and the Target. This is useful if surrounding components around the Solder part are that high that they prevent connecting the Emulation Adapter. Keep number of Extenders at minimum since every Extender degrades signal integrity of the electrical signals.

3. Connect the Emulation Adapter to the Solder part respectively to the Extender when it's being used.

4. Connect Debug Adapter or Active Probe to the connector on the Emulation Adapter.

Gently press the Emulation Adapter with your thumb to the Target board and keep it stable. With your other hand carefully align the debugger's connecting cable with the matching connector on the Emulation Adapter. Press the cable carefully straight down until a good connection is established.

To prevent breaking of the hardware setup or just part of it, avoid disconnecting and connecting the hardware setup too frequently.