winIDEA HelpDebug
Before you can start debugging, you need to configure and establish an Active Debug Session with your target microcontroller.
Getting started - Tutorial
Debug Session simplified
Once the debug configuration is ready, a Debug Session can be started. This happens with any of these commands:
•Debug / Reset - Establishes control of the device at its reset point within an active session, this will only reset the device.
•Debug / Download - Establishes control of the device at its reset point and programs FLASH and RAM.
•Debug / Load Symbols Only - Establishes control of the device at its reset point.
•Debug / Run - Same as Debug / Download but after programming the device is set to running.
•Debug / Attach - Establishes control of a running device without stopping it.
•Debug / Prepare to attach - Initializes the emulator to be ready for device attach.
|
BlueBox initialization |
CPU Reset |
Symbols (ELF) update |
Program specified files in the the target memory(s) |
Set target to run |
|---|---|---|---|---|---|
Reset |
|
|
*only from OFFLINE |
|
|
Download |
|
|
|
|
|
Load Symbols Only |
|
|
|
|
|
Run |
|
|
|
|
|
|
When a Debug Session is already active, the Download and Load Symbols Only will end the current session and start a new one. |
More resources
