winIDEA HelpOne flat ribbon cable
Debug Adapters, which come with a detached ribbon cable, connect always to DTM #1 connector located on top of the BlueBox.
|
Connect the ribbon cable to the DTM #1 connector. |
The cable should be facing away from the BlueBox with the red (edge) wire on the side of the DTM #1 marking. Align the orientation key/notch of the cable connector with the notch on the BlueBox connector marked with #1. Press the cable connector carefully straight down until the latches lock.
|
Connect the Debug Adapter to the other side of the ribbon cable. |
Align the orientation key/notch on the Debug Adapter connector with the connector on the flat ribbon cable. Press the cable carefully straight down until the latches lock.
|
Connect the Debug Adapter to the Target. |
Refer to the chapter Debug Adapter and Target.
|
Disconnect. |
In order to disconnect the flat ribbon cable from the DTM #1 connector, squeeze the two metal latches on the cable connector from the side and pull the cable from the DTM #1 connector.
