winIDEA HelpDebug Adapter and Target
This chapter describes how to connect a Debug Adapter and a Target.
|
The connector has a locking mechanism. Push carefully (and remove) and PARALLEL both sides and listen for the “click”! |
|
Ensure that both the BlueBox and the Target are not powered. |
|
Ensure that the Grounding wire is securely connected. |
|
Connect the Debug Adapter to the Target. |
Pin 1 can the Target can be marked by:
- a small dot next to the connector or
- a number 1 marker or
- a small triangle marker imprinted into the connector plastic, etc.
If the target connector doesn't provide a key pin or a key notch, make sure pin 1 is properly identified on the Debug Adapter and the Target since a mistake could damage the hardware.
 |
